Precise Determination of Astronomical Azimuth by the Hour Angle Method of Multiple Meridian Stars     

《Chinese Astronomy and Astrophysics》2020,44(4):536-548

  相似文献   

堆积阶地古老滑坡识别方法及其在线状工程地质勘察中的应用     

安玉科  樊江  马胜午  马建全  高娟  毛立军 《吉林大学学报(地球科学版)》2020,50(6):1787-1794

阶地型古老滑坡体形成后，长期受各种营力影响，导致古老滑坡地貌形态破坏严重甚至消失。目前遥感技术和普通工程地质调绘很难发现这些滑坡的存在，给工程建设和后期运营造成较大安全隐患。为准确识别形态特征不明显的古老滑坡体，从阶地物质结构特征演变入手，找到阶地受剪切破坏产生的典型物质结构特征，将地层结构错断、卵砾石异常定向排列、摩擦镜面和泥包粒的眼球构造等作为滑坡准确识别依据。首先采用沿沟谷进行工程地质测绘的纵横交错追踪法确定滑坡体纵向范围和滑面形状，再结合地貌特征推测各级、块滑坡平面范围和分布，最后用点状勘探工程验证和校正推测结论。可将其总结为由"地貌异常、沿沟追踪、面上推断、点状校验"组成的阶地型滑坡识别方法，即物质结构异常推断法。结合线状工程勘察设计各阶段工作特点，提出线状工程前期工作中阶地型滑坡识别步骤，并在临渭高速公路工程建设项目中取得成功应用。  相似文献   

全球主要河流流域碳酸盐岩风化碳汇评估   总被引：7，自引：0，他引：7  

李朝君  王世杰  白晓永  谭秋  李汇文  李琴  邓元红  杨钰杰  田诗琪  胡泽银 《地理学报》2019,74(7):1319-1332

碳酸盐岩风化吸收的大气CO₂主要以HCO₃ ^-形式连续地经由河流从大陆输送到海洋,成为陆地生态系统的重要碳汇。目前主要河流流域的碳酸盐岩风化碳汇估算存在不确定性,分布格局尚不清晰。基于GEMS-GLORI全球河流数据库提供的全球10万km ²以上主要河流流域多年平均监测数据,利用水化学径流法估算出全球主要河流流域碳酸盐岩对CO₂的吸收速率为0.43±0.15 Pg CO₂ yr ^-1,平均CO₂吸收通量为7.93±2.8 t km ^-2 yr ^-1。CO₂吸收通量在不同气候带下差异显著,热带和暖温带CO₂年吸收速率占全球主要河流流域年吸收速率的62.95%。冷温带CO₂年吸收速率占全球主要河流流域的33.05%,仅次于热带地区。本文划分出全球CO₂吸收通量的9个关键带,关键带的交汇处CO₂吸收通量较高。喀斯特出露流域碳酸盐岩对CO₂吸收通量的均值为8.50 t km ^-2 yr ^-1,约为非喀斯特流域的3倍。全球喀斯特出露流域碳酸盐岩风化碳汇在全球碳循环、水循环及碳收支平衡估算研究方面占据重要地位。  相似文献   

杭州湾中部实测波浪特性分析   总被引：1，自引：0，他引：1  

杨斌  杨忠良  叶钦  张俊彪  施伟勇 《海洋工程》2018,36(3):96-103

利用杭州湾中部一年实测波浪资料,分析该地区的波参数统计变化特性,采用最小二乘法拟合得出相关参数之间的关系式,并统计分析了频谱特性。结果表明:杭州湾中部以小浪和轻浪为主,在各月分布较为均匀,年平均周期为2.97 s;最大一次波浪过程为冷空气影响所致,影响强度大于台风莫拉克;常浪向分布在东北至东南向,其中又以小浪出现较多,对应的波周期以2~4 s为主;强浪向主要分布在西北和东北方向,对应的波周期主要分布在3~5 s;多数特征波参数之间相关关系较好;由谱分析得知风浪占多数,且以单峰为主。研究结果可为相关工程和理论研究提供基础资料。  相似文献   

基于高斯两步移动搜寻法的村镇避难场所可达性研究     

但文羽  肖映辉  胡周灵  詹庆明 《地球信息科学学报》2018,20(10):1412-1421

避难场所可达性是指避难场所与受灾居民之间的通达性,即灾害发生时,避难人员通过避难疏散通道到达避难场所的难易程度,是评价避难场所布局合理性的重要指标。本研究结合高斯两步移动搜寻法和网络分析法,从供需双向出发对村镇地区避难场所进行可达性分析。2种方法的结合,既充分考虑了需求点与设施点的相互作用,又充分考虑了设施点的吸引力随距离的衰减关系,并基于实际道路,以步行疏散时间作为搜索半径,降低了传统研究中因忽略供需间相互作用及实际距离而引起的可达性结果的误差。最后,以神农架松柏镇区为例,验证该方法的实际应用价值。结果表明,该方法能够有效测定村镇地区避难场所的空间可达性,同时,基于GIS软件可以直观地揭示研究区域内避难场所可达性空间分布差异。该方法可为制定科学的村镇防灾减灾规划提供方法支持。  相似文献   

Energy saving performance analysis of contra-rotating azimuth propulsor     

《Applied Ocean Research》2018

The energy saving performance of contra-rotating azimuth propulsor (CRAP) is investigated based on low order potential-based panel method. The hydrodynamic interactions among the forward propeller (FP), rear propeller (RP) and the pod unit (PU) which includes the pod body and the strut are considered through induced velocities which are obtained by panel method. In order to have a better understanding about the energy saving performance of CRAP, the hydrodynamic performance of a conventional propeller (CP) supplying the same thrust with CRAP at design condition is also calculated. At design condition, CRAP has a decrease in delivered power by approximately 8% comparing with CP, and the tangential induced velocities in slipstream show that CRAP recovers the rotational energy of slipstream effectively. At off-design conditions, the rotational speed of CRAP is adjusted to supply the same thrust with CP. In general, the delivered power of CRAP is significantly smaller than that of CP, and the energy saving performance of CRAP increases with the decrease of inflow velocity.  相似文献   

基于经验模态分解和小波分解估算海气通量涡相关计算中的截断时间尺度     

姜浩  赵中阔  樊伟  宋金宝 《海洋与湖沼》2018,49(6):1138-1150

基于时长38天的海表风场实测数据,应用经验模态分解(EmpiricalModeDecomposition,EMD)和小波分解(Wavelet Decomposition, WD)这两种数据处理方法首先对涡相关法中的截断时间尺度(CutoffTimescale,CTS)进行估算,结果显示:基于EMD与WD方法估算出的CTS一般都在40秒左右(EMD的结果略小),远远小于传统涡相关法中CTS的取值(固定为10分钟),且EMD和WD的使用使得每一段数据都能够根据自身的湍流特点而获得合适的CTS; EMD方法和WD方法有效的去除了计算结果中的非湍部分,且对通量传输方向的刻画也更加合理,极大提高了通量的计算精度,所得通量与传统方法计算的通量偏差平均值高达45%;研究还对EMD和WD的优缺点进行了对比分析,结果表明EMD相比于WD有更高的自主性,而WD对信号的分离程度则更高。  相似文献   

Regional extreme‐dry‐spell frequency analysis using the L‐moments method in the middle reaches of the Yellow River Basin,China          下载免费PDF全文

Dun‐Xian She  Jun Xia  Dan Zhang  Ai‐Zhong Ye  Aditya Sood 《水文研究》2014,28(17):4694-4707

In this research, the regional extreme‐dry‐spell frequency in the middle reaches of the Yellow River Basin (YRB) is studied by the L‐moments method. The research area has been divided into three subregions (regions 1, 2 and 3), which have been identified as homogenous regions. The results of a goodness‐of‐fit test indicate that a generalized normal distribution is the optimal regional model for regions 1 and 2 whereas a generalized Pareto distribution is the optimal regional model for region 3. The return period analysis figures out that the maximum length‐of‐dry‐spell (MxDS) values increase from south to north in the southern part and increase from northeast to southwest in the northern part of the middle reaches of the YRB under different return periods. The increments of quantiles of dry spell under different return levels indicate that drought risk in region 1 is higher than that in regions 2 and 3. The analysis of the occurrence day of MxDS shows that MxDS mostly occurred during winter of 1998 and spring of 1999 in most stations during the considered period. By comparing summer MxDS events, it can be found that mean MxDS values have slightly increased in regions 1 and 2 during the last five decades. The maximum mean MxDS values appeared in the 2000s for regions 1 and 2 and in the 1990s for region 3. The atmospheric circulation shows that the positive anomaly centre in the west of North China, negative anomaly centre in the east of North China and the strong western Pacific subtropical high led to the decrease of precipitation in North China during the summer of 1997. Copyright © 2013 John Wiley & Sons, Ltd.  相似文献   

Modeling deepwater seabed steady-state thermal fields around buried pipeline including trenching and backfill effects     

《Computers and Geotechnics》2014

Deepwater pipelines are designed to transport mixtures of oil and gas, and their associated impurities at wellhead temperatures that can be in excess of 149 °C (∼300 °F or 422 K) while the external temperature maybe in the range of 5 °C (∼41 °F or 278 K). Depending on the circumstances these pipelines may be buried for physical protection or for additional thermal insulation using robotic trenching equipment. This results in a complex cut and backfill geometry in the seafloor in addition to altering the thermal properties of the backfill. A two-dimensional boundary element model was developed specifically to address to investigate the local steady-state thermal field in the near field of the pipeline. The model allows one to account for the complex geometries in the near field associated with this burial technique, site-specific multi-layered soil conditions and the seawater adjacent to the seafloor. A parametric study was preformed to evaluate effects of the thermal power loss, burial depth, pipe diameter and soil thermal conductivity on the thermal field in the near field of a buried pipeline. The numerical examples illustrate the influence of the backfill thermal property on the temperature at the pipe wall, that the pipe diameter controls the required output thermal power needed to maintain the desired pipe wall temperature, and the importance of pipeline burial depth on seabed temperature distribution above the pipeline.  相似文献   

Critical Top Tension for Static Equilibrium Configuration of A Steel Catenary Riser     

Chainarong ATHISAKUL  Karun KLAYCHAM  Somchai CHUCHEEPSAKUL 《中国海洋工程》2014,(6):829-842

This paper aims to present the critical top tension for static equilibrium configurations of a steel catenary riser（SCR） by using the finite element method. The critical top tension is the minimum top tension that can maintain the equilibrium of the SCR. If the top tension is smaller than the critical value, the equilibrium of the SCR does not exist. If the top tension is larger than the critical value, there are two possible equilibrium configurations. These two configurations exhibit the nonlinear large displacement. The configuration with the smaller displacement is stable, while the one with larger displacement is unstable. The numerical results show that the increases in the riser＇s vertical distances, horizontal offsets, riser＇s weights, internal flow velocities, and current velocities increase the critical top tensions of the SCR. In addition, the parametric studies are also performed in order to investigate the limit states for the analysis and design of the SCR.  相似文献